While holding one up to figure out how to fit them I enjoyed a shower of ball bearings. So ebay sold me steel sliders with several tiny ball bearings. Where`s the candle grease ? But half way through, my lovely wife decided she wanted nice smooth sliders. That used Victorian style wooden sliders. (Made in Pardubice which is where they manufacture Semtex ). My original plan was to copy the style of our Czech cabinet from a European importer. Surprising that it was my first attempt at dovetails. All the corners were dovetailed almost to professional standard. I made a kitchen cabinet with drawers for pots and pans. I only had to adjust one of the slides left-right in the end, and everything works marvelously now. screwing everything in (using the horizontal-slot screw sites on the rear brackets, allowing me to move it slightly left to right if I needed to) Ħ. sliding the rear face frame bracket against the back of the cabinet ĥ. putting the appropriate spacer between the cabinet side and the drawer slide about 2/3 of the way back into the cabinet, holding the slide in the right front-to-back alignment Ĥ. putting the drawer slide into the cabinet and bringing the front bracket into position against the face frame ģ. Putting the two taller spacers into the right position so that I could rest a drawer slide on them during installation Ģ. With the spacers all made, installing each slide was as easy as:ġ. For each drawer position, I used a piece of scrap wood to make spacers that were the exact width of the space behind the face frame on the left and right sides-I slid the wood behind the face frame and against either the side of the cabinet or the middle support, marked the vertical line where the face frame edge sat, and then cut the spacer on my miter saw (making sure to mark each clearly!) I then made two more spacers on which I could rest the drawer slides to bring them to their intended heights inside the cabinet. The cabinet has two drawer positions, side by side, and has a vertical support running the entire depth of the cabinet that sits between the two drawer positions. I just wanted to follow this up with my actual experience this weekend, which went well!Īs I said a few times, my cabinet has a face frame, so I installed the Accuride drawer slides with their accompanying face frame brackets. Build a quick, rough mocked-up simulation of the drawer, and then use it to position the slide brackets appropriately. Test-mount the brackets on waste wood and take exact measurements Ģ. I figured that there would be good measurements that came with the Accuride brackets that give exact offsets from the outside edges of the brackets to the outside edge of the mounted drawer slides, but that's not the case…īest as I figure, I'll probably just have to do one of two things:ġ. My worry is that it'll be hard to attach the rear bracket to the rear of the cabinet carcase aligned correctly so that it holds the slide front-to-back straight. RobH, same thing-the sides are parallel to each other, so that's not an issue rather, the issue is the addition of the face frame to the mix, which means that the slides are attached to brackets on the face frame and the rear of the cabinet. GaryK, that post assumes slides that are installed on the actual cabinet sides rather than on brackets attached to the face frame and rear of the cabinet it's this that has me concerned that it'll end up being hard to get the slides perfectly straight and parallel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |